The reviews are automatic translation.
Inserting the plate with a chopping bolt
On 2019-11-13 11:05:09
Since it is 2 mm lower (thin) than the normal M10 nut height, it does not interfere with the operating part
For mounting parts
On 2019-09-27 14:48:26
I wanted a small amount, so it was good to buy from a small amount.
There is no problem because the product can be used normally.
Maintenance and repair of machines
On 2019-05-13 18:57:23
I buy things that I use often with M3, M4, M5, M6. If you go to the home improvement shop, it is expensive. Try using, texture is good, I am satisfied.
On 2019-04-10 19:58:43
You can use the quality without any problem. It is good to buy it in small parts and not get in the way, and cospa is also good.
On 2019-03-06 15:13:01
Despite being cheap, the dimensions were accurate, and there were no burrs, and the feeling in use was good.
Assembly parts of our products
On 2019-03-04 20:14:46
This type is thinner than expected, and it may be difficult where tightening torque is required.
On 2019-03-04 20:08:23
It is thinner than planned, and a tightening torque may cause concern.
Screw fastening when there is no space
On 2018-12-26 18:50:27
Three kinds are thin nuts, but it is a special thing not seen so much at home centers. For a rusty environment, we recommend a different plating one.
On 2018-12-05 01:51:37
I purchased a screw nut flat washer with a set for repairing the aluminum workbench. All 10 bench can be repaired and used now.
I used it on the set screw side of the stripper bolt.
On 2018-11-24 11:03:34
Until now, on the tightening side of the stripper bolt of this size, we used nylon nut as a bolt loosening prevention but pretty cost is different, so we wanted to try using this hexagon nut together.
As we could confirm the effect of the loosening stop if we devised a little while screwing in, I think whether it will be OK here in the future.